SBC Macintosh Efficient Networks 5260 Guide d'installation télécharger pdf (Page 5)

5260 Configuration Settings

Efficient Networks, Inc.

5260 Configuration Settings

The following table shows the factory-default configuration of the 5260.

These settings are not user-configurable.

ATM Interface • One Permanent Virtual Circuit supported

• F4/F5 looback cells supported

• Logical Link Control (LLC)/ Subnetwork Access

Protocol (SNAP) encapsulation over ATM per RFC

1483, Multiprotocol Encapsulation over ATM Adapter

Layer 5

Ethernet Interface Up to 10 Mbps, default is half duplex communication

mode

Bridging • LLC encapsulation of Ethernet packets to/from the

ATM interface

• LLC duplication supported (forwards frames whose

source address and destination address are the same)

• Supports learning of up to 1024 MAC addresses

1 2 3 4 5 6 7 8 9 10 11

Pas de commentaire

SBC Macintosh Efficient Networks 5260 Guide d'installation Page 5